Table of Contents
Advertisement
Automatic Setting Method
Measurement is actually performed, and correction values are set for those measurement
values.
FUN mode-[MEAS]-[SENS]-[TASK1 to 8]-[SCALE]-[AUTO]
72
Measurement Settings
MEAS/AUTO
FIRST POINT
SET
MEAS/AUTO
4.95000
[ 5.00000]
OK
INPUT
CORRECT VALUE
1
Set the measurement target in
place, and press the SET key.
2
Input the correction value for the
measurement value on the upper
section.
Note
To change numerical values, use the
↑UP
key/↓DOWN
change the number of digits use the
←LEFT key/→RIGHT key.
3
In the case of two-point scaling
(height, edge position), move the
measurement target, and repeat
steps 1 and 2, to set the 2nd point.
key,
and
to
ZG User's Manual
Advertisement
Table of Contents
