Setting Automatic Output - Omron ZG User Manual

Setting Automatic Output

This function is enabled only when the auto output method is set for serial output. When
[OFF] is set, specify the desired task to output as the parameter when the MEASURE
command is input.
FUN mode-[I/O]-[SERIAL]-[OUTPUT]
Setting value
TASK1, TASK2, TASK3,
TASK4, TASK5, TASK6,
TASK7, TASK8
TASK ALL
PROFILE (A)
PROFILE (B)
ZG User's Manual
Description
The measurement value of the task selected here is serial-output.
(default value: TASK1)
The output format is the same as that of the MEASURE command.
p.136
All tasks 1 to 8 are output. The output format is the same as that of
the MEASURE command.
p.136
The profile is output. The output format is the same as that of the
PROFILE command.
When profile (A) is selected, the profile is output in PROFILE 0
(ASCII) format.
When profile (B) is selected, the profile is output in PROFILE 1
(binary) format.
Auto output of profiles is not possible in the case of AUTO
sensitivity.
p.146
99
I/O Settings