Setting The Sensor Data Loading Method; Setting The Number Of Digits Past The Decimal Point - Omron ZG User Manual

Setting the Sensor Data Loading Method

Various data is saved in the Sensor. Set at which timing this information is to be loaded to
the Controller.
FUN mode-[SYSTEM]-[Sensor DATA]
Setting value
Sensor
CONTROLLER
Setting the Number of Digits Past the
Decimal Point
Set the number of display digits past the decimal point that are displayed in the
measurement result on the monitor.When five or less digits are set, the digits are disabled
from the rightmost digit first.
FUN mode-[SYSTEM]-[DIGIT]
Setting value
5, 4, 3, 2, 1
Note
The number of digits past the decimal point in serial output follows the setting made here.
ZG User's Manual
Description
Reads the data currently saved on the Sensor each time that the
Controller is started up. (default value)
Data is not read from the Sensor when the Controller is started up if
the same Sensor at the previous startup is connected.
Important
When the combination of Controller and Sensor is fixed, selecting
"CONTROLLER" sometimes results in the Controller starting up
more stably depending on the operating environment.
Description
Sets the number of display digits past the decimal point.
(default value: 3)
105
System Settings