Omron ZG User Manual page 69

Automatic Setting of Regions
The region is automatically set merely by enclosing the desired measurement area.
Note
Automatic setting can be executed by the same procedure regardless of the mode, EXP
mode or STD mode.
FUN mode-[MEAS]-[SENS]-[TASK1 to 8]-[AUTO]
Important
When there is a step, set so that the center line of the region matches the "area that divides the
top and bottom of the step." When there is an edge, set so that the center line of the region
matches the "edge to be detected."
When there is a step
Center line
ZG User's Manual
TRIMMING
↑↓
50.000mm
←→ 123LINE SET
TRIMMING
↑↓
10.000mm
←→ 450LINE SET
When there is an edge
Center line
1
Adjust the top left of the desired
measurement area, and press the
SET key.
2
Adjust the bottom right of the
desired measurement area, and
press the SET key.
When the desired measurement
area is enclosed, the region in which
measurement points are extracted is
automatically set.
Measurement Settings
67