Setting The Ccd Mode; Setting The Sensor Head Data Loading Method - Omron ZG2 Series User Manual

Setting the CCD Mode

Set the resolution of the Sensor Head's CCD. The profile can be set to high-resolution or
the response time can be speeded up by changing the CCD mode.
Three CCD Modes and Their Characteristics p.23
Important
When the CCD mode is changed, the bank data is initialized. So, be sure to start with teaching
again.
 FUN mode-[SYSTEM]-[CCD MODE]
Setting value
NORMAL
(standard mode)
HI-RESO
(high-resolution mode)
HI-SPEED
(high-speed mode)

Setting the Sensor Head Data Loading Method

Various data is saved in the Sensor Head. Set at which timing this information is to be
loaded to the Controller.
 FUN mode-[SYSTEM]-[HEAD DATA]
Setting value
HEAD
Controller
ZG2 User's Manual
Description
Standard measurement is performed. (default value)
Measurement is performed at a resolution of about four times that
of the standard mode (about two times when the ZG2-WDS70
Sensor Head is used).
Measurement is performed at a higher speed than that of the
standard mode. This mode is suited to measurement of shapes in
fast line speed processes as the measurement cycle is fast.
Note that the possible measurement range in the height direction
becomes roughly 1/2 of that in the standard mode.
Description
Reads the data currently saved on the Sensor Head each time that
the Controller is started up. (default value)
Data is not read from the Sensor Head when the Controller is
started up if the same Sensor Head at the previous startup is
connected.
Important
When the combination of Controller and Sensor Head is fixed,
selecting "CONTROLLER" sometimes results in the Controller
starting up more stably depending on the operating environment.
121
System Settings