7.2. Setting Up the Digital Sensor Communication Unit
Set Up the Digital Sensor Communication Unit.
7.2.1.
Hardware Settings
Set the hardware switches on the Digital Sensor Communication Unit.
Precautions for Correct Use
Make sure that the power supply is OFF when you perform the setting up.
1
Confirm that the power supply to
the Digital Sensor
Communication Unit is OFF.
*If the power supply is turned
ON, settings may not be
applicable as described in the
following procedure.
2
Connect the Digital Sensor
Communication Unit to the Fiber
Amplifier, and attach the
protective cap.
Check the hardware switches on
the Digital Sensor
Communication Unit by referring
to the figure on the right.
3
Set the node address switches
as follows.
100: 0
10: 1
1: 7
*Set the node address to 017.
7. Connection Procedure
Digital Sensor Communication
Fiber Amplifier
Node address switches
Protective cap
Node address setting (100)
Node address setting (10)
Node address setting (1)
11