Table of Contents
Advertisement
coolant slowly until the coolant level is at
the upper limit of the middle part. Then
cover the radiator cap.
1 Accumulator, 2 Radiator water inlet
In the added coolant, the proportion of
antifreeze and pure water should always
be kept at half. Do not only add antifreeze
or pure water.
A funnel should be used when refilling to
prevent the coolant from flowing out. Also
check the water pipe of the accumulator for
leakage or damage, if it is leakaged or
damaged, replace it.
If the accumulator is empty, check the
coolant level of the radiator. Turn the
radiator cap counterclockwise to see if the
coolant level reaches the bottom of the
neck of the radiator injection port. If not,
add coolant.
difficult to start, other faults have been
eliminated. When it is suspected that the
cylinder pressure is abnormal, check the
cylinder pressure.
Cylinder pressure: ≥ 0.6 MPa/ 300 rpm.
During the test, remove the spark plug,
install
the
pressure
installation place of the spark plug, fully
open the throttle handle, start the engine
by electricity, and check whether there is
air leakage at each connection part of the
pressure gauge. Set the pressure gauge to
zero and start the engine again until the
pressure
gauge
maximum indication of the pressure gauge
is usually reached after 1-2 starts. The
maximum
indication
pressure. After the test, install the spark
plug back to its original position.
1 Turn the key clockwise, 2 Fully open the
throttle handle, 3 Press the electric start
button
gauge
at
the
stops
rising.
The
is
the
cylinder
Advertisement
Table of Contents
