Malaguti DRAKON125 2022 Workshop Manual page 81

Maintenance requirements
Sequence
Disassembly sequence
1 Brake switch plug
Clamp bolt of front brake master
2
cylinder
3 Front brake cylinder block
components
4 Clutch switch plug
5 Clutch line
6 Counterweight bolt
7 Counterweight
8 Left handlebar
9 Clutch handle bolt
10 Clutch handle
11 Left combined switch screw
12 Left combined switch
13 Fuel feeder seat screw
14 Fuel feeder seat
15 Throttle cable
16 Fuel feeder
17 Right combined switch screw
18 Right combined switch
19 Clip bolt M8×35
20 Clip
21 Handlebar
Procedure Quantity
The installation sequence is reverse to the disassembly sequence
2
Note: 1. First tighten the upper bolt, and then tighten the
2 lower bolt; 2. There are two raised triangular marks on
the clip pointing upward
1
2
1
2
2
The handle mark is aligned with the marking point of the
1
handlebar
Align the handle opening with the marking point of the
1
handlebar
1
2 Note: Tighten the upper bolt first, then the lower bolt
1
2 Note: Tighten the front bolts first, and then the rear bolts
1
2 Note: do not bend or twist the throttle cable
1
2 Note: Tighten the front bolts first, and then the rear bolts
1
4 Note: Tighten the front bolts first, and then the rear bolts
1
2 Pay attention to the position of marks during installation
Remark