Table of Contents
Advertisement
motorcycle shall be supported on the flat
ground with side bracket, and the cooling
water and engine lubricating oil shall be
drained.
In order to maintain the cylinder head,
cylinder block, piston and other heat
engine parts, it is necessary to remove the
cover, oil tank, radiator, throttle body, air
filter assembly, etc.
If you need to remove the left front cover of
the engine for maintenance, you need to
remove the transmission pedal and left
rear cover, etc.
The installation sequence is reverse to the
disassembly sequence.
When resuming installation, all wiring
pipes shall be arranged according to the
wiring diagram, and the removed hoops
shall be replaced with new ones.
Disassembly of engine
Park the motorcycle on the flat ground and
drain the cooling water and engine
lubricating oil.
Remove the cover, oil tank, muffler and
radiator (refer to relevant chapters).
Disassembly of clutch cable.
Important torque figures
Engine suspension bolt M10: 55 ～ 65
N.m
Disassembly of left rear cover
Remove the drive chain
Remove the starting motor wire and engine
Advertisement
Table of Contents
