Table of Contents
Advertisement
3. When fastening bolts or nuts, they shall
be carried out in diagonal cross sequence
and tightened step by step in 2-3 times to
reach the specified standard torque value.
4. After the parts are disassembled, they
shall be cleaned before inspection and
measurement.
When cleaning parts, non combustible or
high ignition point cleaning fluid shall be
used.
Before assembly, the sliding surface of
parts shall be applied with the specified
lubricating oil.
After assembly, check whether all parts
are installed correctly. Rotate, move,
operate, check are required.
5. Special and general tools must be used
in
assembling
and
disassembling
motorcycles.
6. The specified or equivalent grease (oil)
must be applied or injected at the
specified place.
7. When there are more than two people
operate the motorcycle, they should care
each other's safety and work together.
8. Before operation, the negative terminal
(-) of the battery must be removed, and
the spanner should not touch the frame.
After the operation, the connection,
fixation and connection of each part shall
be confirmed again. If the battery has
been removed, the positive terminal (+)
Advertisement
Table of Contents
