Table of Contents
Advertisement
3. Deformation or looseness of wheel
spokes
4. Front axle is loose
5. Tire is damaged
Disassembly / assembly of control sub-assembly
Note
The front brake master cylinder shall be hoisted with steel wire rope, and its height shall
be at least the same as that of the original installation position, so as to prevent air from
invading the master cylinder and affecting the braking performance. It is forbidden to twist
the brake hose.
When assembling clutch handle and front brake cylinder block, the opening shall be
aligned with the marking point of handlebar.
The opening at the back end of the clip is aligned with the marking point of the handlebar.
First tighten the front bolt of the clip, and then the back bolt.
After installation, adjust the throttle control line.
Poor brake performance
1. There is air in the brake pipe;
2. The brake shoe is worn;
3. There is water or oil on the brake shoes.
Advertisement
Table of Contents
