Table of Contents
Advertisement
the tension of the drive chain. The method
is to press the chain up and down with your
fingers to check the up and down
movement of the chain below.
Sag of transmission chain: 15 ~ 25 mm.
If the chain is too loose or too tight, it needs
to be adjusted.
Adjustment method:
Loosen the rear shaft nut, turn the
adjusting nut on the chain adjuster, tighten
the rear shaft nut after reaching the
specified chain tension, and check the free
rotation flexibility of the rear wheel and the
consistency of the front and rear wheels.
Rear axle nut
Battery
Disassembly of battery
First remove the cushion, removethe
fuel tank fasten bolts.First remove the
positive pole, next remove the positive
pole, then loosen and remove the fastening
If it is damaged, replace the chain. Then
install the chain and apply the special
lubricant for the chain;
Check the worn condition of large and
small chain wheels. If the gears are
seriously worn, missing or broken, they
should be replaced
Note:
Apply proper amount of chain special
lubricating oil on the connecting shaft of
lock plate.
Note:
The chain of the car is connected by
locking plate. During installation, the open
end of the spring clip of the chain joint
should be opposite to the movement
direction of the chain.
Sagging degree
Riser steering bearing
Support the motorcycle with a jack or
other bracket to make the front wheel off
the ground, and check whether the
steering handle can rotate freely. If the
Advertisement
Table of Contents
