Inspection of flat fork shaft
Place the flat fork shaft on the V-shaped seat,
and test the deflection of the flat fork shaft with
a dial indicator. If the figure goes beyond or
equal to 0.2 mm, replace the flat fork shaft
with a new one.
Disassembly/assembly steps of rear fork
Refer
to
the
figure
below
for
the
disassembly/assembly of the rear fork.
The sealing ring and needle roller bearing
should be replaced after removal. After the
needle bearing is installed, make sure that it
is 3 mm away from the end, and the needle
shall be coated with lithium grease. After
installation, check whether the needle roller
bearing rotates flexibly.