Table of Contents
Advertisement
frame. The clamps shall clamp the wire
bundles correctly. The wire harness shall
be clamped at the place that is not in
contact
with
the
temperature, The wire harness shall be
clamped at the place that is not in contact
with the edge and acute corner of the
vehicle body. And the wire harness shall
not pass through the place where it
contacts with the head and front part of
bolts and screws. The wire harness
should not be loosened or pulled by force.
If the wire harness needs to contact with
the edge and acute corner in any case, it
should be protected with hose or tape at
the contact part.
Do not break the covering of the wire
harness. If the wire harness is damaged,
it should be repaired by winding with
plastic tape.
Do not press on the wire harness when
installing parts.
Do not twist the wire harness.
part
with
high
the limit position, the wire bundle shall not
be too tight and too loose, and it should be
confirmed that there is no prominent
bending,
pressed
interference and other phenomena.
14. When using the test table, you should
understand the instructions in the operation
manual and operate according to the
maintenance manual.
15. Do not drop or throw any parts.
16. If the terminal is rusted, it shall be
treated with sandpaper before connecting.
17. Cables should not be twisted or bent by
force. Because the deformed or damaged
cable is the cause of poor operation and
damage.
phenomenon,
edge
Advertisement
Table of Contents
