Malaguti DRAKON125 2022 Workshop Manual page 125

rusted and cannot be connected.
Front brake light switch
1. Outline drawing
2. Working principle
When braking, hold the brake handle tightly, and the contact contacts with the conductive
elastic sheet under the action of spring force, so as to connect the circuit, and the brake
light is on. Release the brake handle, press the brake handle against the switch guide
rod, compress the spring, make the contact leave the conductive spring, the circuit is
disconnected, and the brake light goes out.
3. Basic parameters
The opening stroke of the switch is 2mm and the full stroke is 4mm.
4. Possible failures
The contact and shrapnel are rusted and in poor contact;
The switch is stuck and the guide rod can not act;
The leading out insert is broken or rusted.
Rear brake switch
1. Outline drawing