Malaguti DRAKON125 2022 Workshop Manual page 91

Maintenance Instructions
This section describes the removal, installation and maintenance of the rear wheel, rear
brake, rear fork, rear shock absorber and rocker link. When performing repair and
maintenance for the rear wheel, rear shock absorber and rocker arm connecting rod, the
motorcycle should be reliably supported by an air jack or other bracket under the engine.
Important torque figures
Fastening nut on rear axle shaft: 75 ～ 85N.m
Nut on rear fork shaft: 75 ～ 85N.m
Damping rocker arm M10 bolt and nut 45 ~ 55N.m. Damping rocker arm M12 bolt and nuts
60 ~ 70N.m
Fastening screw on brake disc : 28 ~ 32N.m
Troubleshooting
Swings of the rear wheel
1. Deformation of wheel rim;
2. The rear wheel bearing is worn;
3. Low tire pressure;
4. Inconsistency in the left and right of the
regulator;
5. Damaged wheel sleeve.
Noise
Loose fasteners.
Rear wheel
Difficulty in turning the wheel.
1. Damaged wheel bearing and shaft
sleeve;
2. Incorrect wheel installation;
3. Bent rear axle
3. Rear brake friction plate can not reset
Abnormal suspension
1. The damping spring is too hard or too
soft ;
2. Damaged rear fork bearing;
3. Bent shock absorber.