Table of Contents
Advertisement
Cylinder pressure ≥0.6MPa/300rpm
Spark plug
Remove spark plug cap Remove the
spark plug with socket wrench. Check
whether the spark plug insulator is
damaged and whether the electrode is
ablated. If it is damaged , replace it.
Check the electrode clearance with a
feeler gauge. The electrode clearance
of spark plug is 0.6~0.7 mm. Adjust the
clearance carefully. Then use spark
plug cleaner or steel wire to remove
carbon and dirt. Check whether the
spark plug gasket is in good condition.
To install the spark plug, first screw the
spark plug in and tighten it by hand,
and then tighten it by socket wrench.
Put on the spark plug cap.
Timing phase
It is carried out in a new car or when the
timing phase is suspected.
Remove the left front cover, rotate the rotor
fastening bolt clockwise to make the "I"
mark on the rotor align with the closing box
when it is on the right side, and remove the
Tire pressure
Front wheel Single: 220 kPa, double: 220
kPa
Rear wheel Single: 250 kPa, double: 250
kPa
Tire size
Front wheel 100/80-17 M/C 52S
Rear wheel 130/70-17 M/C 62S
Coolant
Support the motorcycle on the flat ground
with a special fixture, loosen the bolts on
the lower side of the water pump to see if
there is coolant overflow. Tighten the bolts
after inspection.
Advertisement
Table of Contents
