Table of Contents
Advertisement
a. To detach the rear drive cage from system board, loosen the captive screws.
b. To detach the drive cage from the rear panel, loosen the thumbscrews.
c. Grasp and lift the rear drive cage out of the chassis.
8. Remove the drive backplane.
To replace the component, reverse the removal procedure.
Removing and replacing the two-bay SFF rear drive cage backplane
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
CAUTION: To prevent damage to electrical components, take the appropriate anti-static precautions before
beginning any installation, removal, or replacement procedure. Improper grounding can cause electrostatic
discharge.
Prerequisites
Before you perform this procedure, make sure that you have the components included with the hardware kit.
88
Removal and replacement procedures
Advertisement
Table of Contents
