Table of Contents
Advertisement
Item
Description
1
Power On/Standby button and
system power LED
2
UID button/LED
1
3
Health LED
1
4
NIC status LED
5
Front drive health/thermal LED
1
When these four LEDs flash simultaneously, a power fault has occurred.
2
Facility power is not present, power cord is not attached, no power supplies are installed, power supply failure has occurred, or the front
I/O cable is disconnected.
3
If the health LED indicates a degraded or critical state, review the system IML or use iLO to review the system health status
4
This LED behavior applies to all front drives, as well as to the rear drives connected to the internal drive cage backplane.
Status
•
Solid green = System on
1
•
Flashing green (1 flash per second) = Performing power on
sequence
•
Solid amber = System in standby
•
Off = No power present
1
•
Solid blue = Activated
•
Flashing blue:
◦
◦
◦
◦
◦
◦
•
Off = Deactivated
•
Solid green = Normal
•
Flashing green (1 flash per sec) = iLO is rebooting
•
Flashing amber = System degraded
•
Flashing red (1 flash per sec) = System critical
•
Solid green = Link to network
•
Flashing green (1 flash per second) = Network active
•
Off = No network activity
•
Solid green = Drives supported by the SAS expander are functional.
•
Solid amber = Failure or predictive failure of one or more drives
supported by the SAS expander
•
Off = No power present
2
1 flash per second = Remote management or firmware upgrade
in progress
4 flashes per second = iLO manual reboot sequence initiated
8 flashes per second = iLO manual reboot sequence in progress
1 fast flash and then off for 3 seconds = iLO Service Port status
is Complete
4 medium flashes and then off for 1 second = iLO Service Port
status is Busy
8 fast flashes and then off for 1 second = iLO Service Port status
is Error
2
3
3
4
Component identification
4
153
Advertisement
Table of Contents
