Table of Contents
Advertisement
To replace the component, reverse the removal procedure.
Removing and replacing the cable management holder
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
CAUTION: To prevent damage to electrical components, take the appropriate anti-static precautions before
beginning any installation, removal, or replacement procedure. Improper grounding can cause electrostatic
discharge.
Prerequisites
Before you perform this procedure, make sure that you have the components included with the hardware kit.
Procedure
1. Power down the system (Power down the system).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the system.
3. Remove the system from the rack (Remove the system from the rack).
4. Place the system on a flat, level surface.
5. Remove the access panel (Remove the access panel).
6. Remove the air baffle (Remove the air baffle).
7. Open the cable management holder.
8. Disconnect all the cables from the system board connectors located underneath the cable management holder.
9. Remove the cable management holder.
Removal and replacement procedures
109
Advertisement
Table of Contents
