Removing And Replacing An Hpe Persistent Memory Module - HPE ProLiant DX4200 Gen10 Maintenance And Service Manual

5. Remove the access panel (Remove the access panel).
6. Remove the air baffle (Remove the air baffle).
7. Remove the DIMM.
To replace the component, reverse the removal procedure.

Removing and replacing an HPE Persistent Memory module

For specific population and configuration information, see the memory population guidelines on the Hewlett Packard
Enterprise website (http://www.hpe.com/docs/memory-population-rules).
To identify the HPE Persistent Memory modules installed in the system, see HPE Persistent Memory module label
identification.
Procedure
1.
Observe the following alerts:
CAUTION: Electrostatic discharge can damage electronic components. Be sure you are properly grounded
before beginning this procedure.
CAUTION: Failure to properly handle HPE Persistent Memory modules can damage the component and the
system board connector.
2. Power down the system (Power down the system).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the system.
4. Remove the system from the rack (Remove the system from the rack).
5.
Place the system on a flat, level surface.
6. Remove the access panel (Remove the access panel).
64
Removal and replacement procedures