Table of Contents
Advertisement
Prerequisites
Before you perform this procedure, make sure that you have the components included with the hardware kit.
Procedure
1.
Power down the system (Power down the system).
2.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the system.
3.
Remove the system from the rack (Remove the system from the rack).
4.
Place the system on a flat, level surface.
5.
Remove the access panel (Remove the access panel).
6.
Pull down the front drive cage release latches and use them to completely extend the front drive cages from the
chassis (Extend the front drive cages out of the chassis).
7.
Do one of the following:
•
Release the preinstalled Mini SAS x4 cable from the system board cable clips.
•
If a rear drive cage is connected to the internal drive cage backplane, disconnect the preinstalled Mini SAS x4
cable from the rear drive cage backplane.
8.
Remove the cable management holder.
9.
Release the cable track brackets:
a. Loosen the front SFF drive cage cable track thumbscrew, and then release the bracket from the chassis.
100
Removal and replacement procedures
Advertisement
Table of Contents
