Section It; Installation And Operation; Unpacking And Inspection; Preparation For Reshipment And Storage - Watkins-Johnson Company WJ-8718A/MFP Instruction Supplement

WJ-8718A/MFP
INSTALLATION AND OPERATION
SECTION
n
INSTALLATION AND OPERATION
2.1
UNPACKING AND INSPECTION
Paragraph 2.1 of the WJ-8718 Series HF Receiver Instruction Manual is applicable
to the WJ-8718A/MFP Option.
2.2
PREPARATION FOR RESHIPMENT AND STORAGE
Paragraph 2.2 of the WJ-8718 Series HF Receiver Instruction Manual is applicable
to the WJ-8718A/MFP Option.
2.3
INSTALLATION
Paragraph 2.3 of the WJ-8718 Series HF Receiver Instruction Manual is appli-cable
to the WJ-8718A/MFP Option.
2.4 OPERATION
2.4.1 PREPARATION FOR OPERATION
A receiver equipped with an MFP Option can be readied for manual operation by
consulting paragraphs 2.1 through 2.3 in the WJ-8718A HF Receiver Instruction Manual. Proper
operation of the MFP Option can be tested by execution of a Built-In Test Equipment (BITE)
program, described in paragraph 4.1.1.1.
If in addition to the MFP Option, a receiver is equipped with .either the 232M or
488M remote interface option, it can be readied for remote operation by consulting the
appropriate instructions in paragraph 2.4.2 (232 operation) or paragraph 2.4.3 (488 operation).
2.4.2 PREPARATION FOR EIA STANDARD 232 OPERATION
Before remote operation, a WJ-8718A/MFP Receiver with the 232M Option must
be placed in the remote operating mode. The appropriate parameters must then be set on the
I/O board switches and connections as described in the following paragraphs. Refer to
Figure 6-8, Type 796037 I/O Interface Schematic Diagram, when reading
the
following descrip-
tions.
2.4.2.1
Remote Operating Mode
A receiver designated as a listener must be placed in the remote operating mode by
depressing the front panel REMOTE button or if the receiver has not previously been
commanded by a remote device, the first remote m-essage re,ceived after power on will place
.2-1