Equipment Required But Not Supplied - Watkins-Johnson Company WJ-8718A/MFP Instruction Supplement

GENERAL DESCRIPTION
c) Type 791202-5 Encoder Assembly
d) Type 794310- X Front Panel Switch/Encode Assembly
e) Type 796056-1 Front Panel Encode Board
f)Type 794309- X Front Panel Switchboard
WJ-8718A/MFP
The Encoder Assembly and the Front Panel Switch/Encode Assembly with its
subassemblies, the Front Panel Switchboard and Front Panel Encoder, are pre-mounted on the
rear of the MFP Option front panel. Two ribbon cables, MFP- WI and MFP- W2, are supplied to
interconnect the front panel assembly and the two interface boards.
1.4
EQUIPMENT REQUIRED BUT NOT SUPPLIED
A 600 ohm stereo headphone set is required to monitor the audio at the front panel
phones jack. Mono headphones could be used, but LSB would not be monitored in the ISB mode.
If either the 232M or 488M Option is used, compatible remote control equipment is required.
1.5 OPTIONAL EQUIPMENT
The 232M Option consists of the Type 796037 Asynchronous I/O Board, two cables
(232- W2 and 232- W3), an adapter plate (with mounting hardware), two 25-pin D-series
connectors, and two EPROMs.
The 488M Option consists of the Type 796075 I/O Interface, one cable (488-W2), an
adapter plate, one 24-pin Amphenol connector (with mounting hardware), and two EPROMs.
1-4