Locking The Lens Motor; Indicating If The Lens Has A Zoom Motor; Adjusting Primary Colors - Christie BOXER 30 User Manual

Locking the lens motor

Prevents all lens motors from moving. It disables the zoom, focus, and offset settings, locking out any
changes and overriding all other lens features. This feature prevents accidental lens position changes
in multi-projector installations.
1. Select MENU > Configuration > Lens Settings > Lock all Lens Motors.
2. To enable locking of all lens motors, select Enter.

Indicating if the lens has a zoom motor

A zoom motor has a focal length that can be varied, opposed to a fixed, focal length lens.
1. Select MENU > Configuration > Lens Settings > Lens has Zoom Motor.
2. To indicate the lens has a zoom motor, select Enter.

Adjusting primary colors

Calibrate the accuracy of primary colors, which can change because of lighting and environmental
factors.
All primary colors in the projector are precisely set to pre-established values to ensure overall color
performance is optimized and is as accurate as possible. Lighting and other environmental factors may
slightly change how these colors appear on your screen. While the change is negligible in most cases,
you may prefer to recover the originally intended color performance before trying to match colors from
several projectors.
To achieve consistency use a color meter to measure the native primary colors—red, green, blue, and
white—as they appear on the screen. On the basis of these new values, which are stored in memory,
each projector automatically calculates any necessary corrections to reproduce the original factory
colors under the current environmental conditions. This essentially calibrates a projector to its
surroundings, compensating for factors such as screen type, lamp and/or ambient lighting, and
improves color accuracy and consistency in a group of projectors. It ensures a good starting point for
further customizing and matching; however, is not critical for all installations.
1. From the home page, select MENU > Admin > Service.
2. Enter the service password.
3. Select Color Primary Settings.
4. To edit the primary colors, select Edit Primary Colors.
5. Adjust the slider or enter the measured color values of the primary color component you
selected.
6. To confirm your selection, select Enter.
7. Repeat steps 5 and 6 for each primary color component.
8. To view a specific color while adjusting, select Show Color Pattern.
9. Select the appropriate color and select Enter.
10. To reset the primary colors to their defaults, select Reset Color Primaries.
11. At the confirmation prompt, select OK.
Boxer 30 (Bb.2) User Manual
020-102016-02 Rev. 1 (02-2016)
Copyright 2016 Christie Digital Systems USA Inc. All rights reserved.
©
Adjusting the image
19