HPE ProLiant MicroServer Gen10 Plus v2 User Manual page 54

7. Remove the chassis cover .
8. Remove the system board assembly .
9. Remove the expansion slot blank.
Retain the blank for future use.
10. If the expansion card is shipped with an air baffle attached, remove this baffle from the card .
11. If the expansion card is shipped with a full-height bracket attached, replace it with a low-profile one .
12. Make sure that any switches or jumpers on the expansion card are set properly.
For more information, see the documentation that ships with the option.
13. Install the expansion card. Make sure that the card is firmly seated in the slot.
HPE ProLiant MicroServer Gen10 Plus v2 User Guide 54