Front Panel Led Power Fault Codes; Rear Panel Components - HPE ProLiant MicroServer Gen10 Plus v2 User Manual

This LED only reflects the status of drives that are connected to the onboard SATA port.
1
This LED reflects the status of the onboard NIC ports and the optional iLO dedicated network port.
2
When these LEDs flash simultaneously, a power fault has occurred. For more information, see Front panel LED power fault codes.
3
If the health LED indicates a degraded or critical state, use iLO to review the system health status.
4
Facility power is not present, power cord is not attached, or power supply failure has occurred.
5
Subtopics Subtopics

Front panel LED power fault codes

Front panel LED power fault codes
Front panel LED power fault codes Front panel LED power fault codes
The following table provides a list of power fault codes, and the subsystems that are affected. Not all power faults are used by all servers.
Subsystem Subsystem
System board
Processor
Memory
Riser board PCIe slots
FlexibleLOM
Storage controller
System board PCIe slots
Power backplane
Storage backplane
Power supply
PCIe expansion cards installed in riser board 11 flashes
Chassis
GPU card

Rear panel components

Rear panel components
LED behavior LED behavior
1 flash
2 flashes
3 flashes
4 flashes
5 flashes
6 flashes
7 flashes
8 flashes
9 flashes
10 flashes
12 flashes
13 flashes
HPE ProLiant MicroServer Gen10 Plus v2 User Guide 8