HPE ProLiant MicroServer Gen10 Plus v2 User Manual page 21

Remotely: Connect to the iLO web interface and run a remote console:
a. Verify the following:
iLO is licensed to use the remote console feature.
If iLO is not licensed, visit the HPE website:
https://www.hpe.com/info/ilo https://www.hpe.com/info/ilo
The iLO dedicated network port is connected to a secure network.
b. Using a browser, navigate to the iLO web interface, and then log in.
https://<iLO hostname or IP address>
Note the following:
The iLO host name is on the serial number/ iLO information pull tab on the front panel.
If a DHCP server assigns the IP address, the IP address appears on the boot screen.
If a static IP address is assigned, use that IP address.
The default login credentials are on the serial number/ iLO information pull tab on the front panel.
c. Enter the iLO login name and password, and then click Log In.
d. In the navigation tree, click the Remote Console & Media link, and then launch a remote console.
7. Press the Power On/Standby button. For remote management, use the iLO virtual power button.
8. Configure the initial server setup .
9. Set up the storage .
10. Deploy an OS or virtualization software.
11. After the OS is installed, update the drivers.
Server orientation options Server orientation options
HPE ProLiant MicroServer Gen10 Plus v2 User Guide 21