Table of Contents
Advertisement
Station Programming
Station Programming
Stations and Directory Numbers
Defaulting a Station
Setting a Station's Identification
Programming Manual
INDeX 9.1
Normally each station on the INDeX is assigned a single user and user directory
number (see "Assigning Users to Stations" on page 61).
It is possible to have a station with no assigned user directory number. In that case,
the station is referred to in commands by its physical address, e.g. 1/2/0 (that is
cabinet number / slot number / channel number).
You can reset the details of an individual station back to its default values.
Defaulting a station also deletes any user programmed features except the divert
all number.
Note: You can also program the default station settings by entering DEFAULT
rather than a directory number when entering the Station menu.
To default a Station :
1. From the Administration menu, select Station and enter the station's
directory number.
2. Select Default record.
You can give each terminal an identification name. The INDeX uses this within
programming menus and reports.
To change a Station's identification :
1. From the Administration menu, select Station and enter the station's
directory number.
2. Select Identification and enter a name of up to 15 characters.
Station Programming - Page 69
38DHB0002UKDJ – Issue 3 (12/00)
Page 69
Advertisement
Table of Contents
