Changing The Bootloader Timeout; Portvision Dx - Changing Bootloader Timeout; Socketserver - Changing Bootloader Timeout - Pepperl+Fuchs ICDM-RX/TCP-DB9/RJ45-PM Installation And Configuration Manual

ICDM-RX/TCP Installation and Configuration Guide

Changing the Bootloader Timeout

8.7. Changing the Bootloader Timeout
If SocketServer fails during the upload process, you should change the Bootloader timeout value to 45
seconds.
Note: The ICDM-RX/TCP must be able to communicate using an IP address, which is compatible with this
local network. If necessary, refer to Configuring the Network Settings (PortVision DX) on Page 28.

8.7.1. PortVision DX - Changing Bootloader Timeout

Use the following procedure to change the Bootloader timeout to 45 seconds. You can use this procedure to
return the Bootloader timeout to 15 seconds after you have successfully uploaded SocketServer.
1. If necessary, start PortVision DX, from Pepperl+Fuchs Comtrol > PortVision DX.
2. Right-click the ICDM-RX/TCP and click Properties.
3. Type 45 in the Bootloader Timeout text box and click Apply.
Note: You should return the Bootloader Timeout value back to 15 seconds after you upload SocketServer.

8.7.2. SocketServer - Changing Bootloader Timeout

Use the following procedure to change the Bootloader timeout to 45 seconds. You can use this procedure to
return the Bootloader timeout to 15 seconds after you have successfully uploaded SocketServer.
1. If necessary, use your browser to access the ICDM-RX/TCP using the IP address.
2. Click Network.
3. Enter 45 in the Boot Timeout field and click Save.
Note: You should return the Bootloader Timeout value back to 15 seconds after you upload the firmware.
98