Checking The Ns-Link Version; Restoring Serial Port Settings; Ns-Link Com Port; Socket Port - Pepperl+Fuchs ICDM-RX/TCP-DB9/RJ45-PM Installation And Configuration Manual

ICDM-RX/TCP Installation and Configuration Guide

Checking the NS-Link Version

8.10. Checking the NS-Link Version

Use this procedure to check the NS-Link web page version. Remember, an NS-Link version displays when the
NS-Link device driver has been installed and configured, NS-Link is the same firmware as SocketServer.
1. Start PortVision DX.
2. If necessary, click Scan to locate the ICDM-RX/TCP.
3. Contact Technical Support at https://www.pepperl-fuchs.com to see if a later version of SocketServer is
available.
To check the NS-Link version, you will need to check to see what version of SocketServer is available.
4. Compare the version number displayed in PortVision DX to the version displayed on the web site.
5. If a higher version of SocketServer is available and you want to update the ICDM-RX/TCP with the latest
software:
a. Update SocketServer using Uploading SocketServer with PortVision DX on Page 30.
b. Download the latest driver from the Pepperl+Fuchs web site.
c. Upload SocketServer to the ICDM-RX/TCP using PortVision DX or the SocketServer web page.

8.11. Restoring Serial Port Settings

Use the web page and/or the NS-Link device driver for Windows to restore the serial port settings to their
default values.
The NS-Link serial port settings are independent of the socket serial port settings on the web page. If you are
using COM ports and also have configured the port for socket services, you must restore the default port
settings in the driver and web page.

8.11.1.NS-Link COM Port

You can use this procedure to reset NS-Link serial port settings.
1. Open the Windows Drivers Management Console using Pepperl+Fuchs Comtrol>Windows Driver
Management Console
2. Highlight the first port that you want reset to default values.
3. Click the Defaults button (and if appropriate, Clone).
4. Click Apply or OK.
If necessary, you can reset ICDM-RX/TCP device properties to their defaults on the Device General tab using
the Defaults button.

8.11.2.Socket Port

Use the following procedure to reset the socket port serial settings.
1. Open the ICDM-RX/TCP web page (Accessing Socket Configuration on Page 46).
2. Click System | Restore Defaults.
102