Redboot Command Overview - Pepperl+Fuchs ICDM-RX/TCP-DB9/RJ45-PM Installation And Configuration Manual

ICDM-RX/TCP Installation and Configuration Guide

RedBoot Command Overview

9.10. RedBoot Command Overview
The following table is an overview of RedBoot commands available. After accessing RedBoot, you can review
the list of commands on-line by entering help and pressing the Enter key..
auth
{noaccess, none, basic, md5,
invalid}
baudrate [-b <rate>]
boardrev†
cache [ON | OFF]
catalognum [catalog number]†
channel [-1|<channel number>]
chassis†
cksum -b <location> -l <length> Computes a 32-bit checksum [POSIX algorithm] for a range of memory.
clearconfig
cpufreq†
delaycal <passes>†
deviceid [device id]†
disable
dump -b <location> [-l <length>]
[-s] [-1|-2|-4]
eepromvers [ver]†
fis {cmds}
flash
go [-w <timeout>] [-c] [-n] [entry] Executes code at a location.
help <topic>
history
hwflags†
ip [addr mask gateway]
load [-r] [-v] [-h <host>]
[-p <TCP port>]
[-m <varies>]
[-c <channel_number>]
[-b <base_address>]
<file_name>
loop 232|422|int port-number
mac†
RedBoot Commands
Sets or displays web authentication. The default is set to none, which
means that there is no authentication required to access the web server.
To deny access to the web server, click noaccess or invalid. If access
is attempted, a message appears to notify the user that access is
denied.
To configure the web server to request an un-encrypted password, click
basic. To configure the web server to request an encrypted password,
click md5. (Some browsers do not support the md5 command.)
Set/Query the system console baud rate.
Displays the board revision.
Manages machine caches.
Shows catalog number.
Displays or switches the console channel.
Displays chassis information.
Clears the application configuration.
Shows CPU clock frequency.
Calibrates SDRAM clock delay.
Shows the Device ID.
Disables automatic load of the default application.
Display (hex dump) a range of memory.
Shows the eeprom version.
Manages flash images.
Shows flash information.
Displays available RedBoot commands.
Displays command history.
Shows the HW feature flags.
Displays or sets the IP address configuration.
Loads a file.
Runs a loopback test on the port.
Displays the Ethernet MAC address.
117