ICDM-RX/TCP Installation and Configuration Guide
Remote Using the IP Address
8.4.1. Remote Using the IP Address
Use the following procedure to add a remote ICDM-RX/TCP to PortVision DX.
1. Right-click a folder or a RocketLinx switch and click Add New > Device.
2. Select the appropriate ICDM-RX/TCP in the Device Type drop list.
3. Select the appropriate model in the Device Model drop list.
4. Enter a friendly device name in the Device Name list box.
5. Select REMOTE for the Detection Type.
6. Optionally, enter the serial number in the Serial Number list box.
7. Enter the IP Address for the ICDM-RX/TCP. It is not necessary to enter the Subnet Mask and Default
Gateway.
8. Click OK to close the Add New Device window. It may take a few moments to save the ICDM-RX/TCP.
9. If necessary, click Refresh for the new ICDM-RX/TCP to display. The ICDM-RX/TCP shows OFF-LINE if it
is not attached to the network or if an incorrect IP address was entered.
91