Configuring Passwords - Pepperl+Fuchs ICDM-RX/TCP-DB9/RJ45-PM Installation And Configuration Manual

ICDM-RX/TCP Installation and Configuration Guide

Configuring Passwords

If this is an SSH session, type admin for the login and the ICDM-RX/TCP has a password configured, type
the password and press Enter
7. Type auth and press Enter to
see the authentication status,
none indicates that there is no
authentication set.
8. Type auth basic and press
Enter to enable enforcing log-
in functionality.
9. Type reset and press Enter.
10. Close the PuTTY window.
PortVision DX temporarily
displays that ICDM-RX/TCP
as OFF-LINE until the next
polling cycle because the
ICDM-RX/TCP is rebooting.
To disable enforcing log-in
functionality, type auth none.
6.6.2.2. Configuring Passwords
Use the following procedure to configure a ICDM-RX/TCP password.
1. Highlight the ICDM-RX/TCP that you want to configure for a password and click Telnet / SSH Session.
2. Click the Telnet or SSH option, leave the Selected Port number as 23, and click Ok.
3. If you select SSH, click Yes to the PuTTY Security Alert.
73