Table of Contents
Advertisement
ICDM-RX/TCP Installation and Configuration Guide
Hardware Installation
2. Hardware Installation
This chapter discusses:
•
ICDM-RX/TCP-DB9/RJ45-PM and ICDM-RX/TCP-DB9/RJ45-PM2 Installation
•
ICDM-RX/TCP-ST/RJ45-DIN Installation on Page 13
•
ICDM-RX/TCP-DB9/RJ45-DIN Installation on Page 14
•
ICDM-RX/TCP-2ST/RJ45-DIN Installation on Page 16
•
ICDM-RX/TCP-2DB9/RJ45-DIN Installation on Page 17
•
ICDM-RX/TCP-4DB9/2RJ45-DIN Installation on Page 19
•
ICDM-RX/TCP-4DB9/2RJ45-PM Installation on Page 21
•
ICDM-RX/TCP-8DB9/2RJ45-PM Installation on Page 22
•
•
Adding a Unit to an Existing Installation on Page 24
•
Replacing Hardware on Page 25
2.1. ICDM-RX/TCP-DB9/RJ45-PM and ICDM-RX/TCP-DB9/RJ45-PM2
Installation
Use the following procedure to install the ICDM-RX/TCP-DB9/RJ45-PM or ICDM-RX/TCP-DB9/RJ45-PM2.
1. Place the or ICDM-RX/TCP-DB9/RJ45-PM2 on a stable surface and skip to Step 2 or optionally mount the
ICDM-RX/TCP-DB9/RJ45-PM or ICDM-RX/TCP-DB9/RJ45-PM2 using the mounting flanges or DIN rail
adapters.
a. Pick up the ICDM-RX/TCP-DB9/RJ45-PM or ICDM-RX/TCP-DB9/RJ45-PM2 so that the front of the
device is facing you.
b. Pick up a DIN rail clip. (The three tines should be on top and the M4 label should
face you.)
c. Slide the DIN rail clip behind the ICDM-RX/TCP-DB9/RJ45-PM or ICDM-RX/TCP-
DB9/RJ45-PM2 and line it up with one of the screw holes on the ICDM-RX/TCP-
DB9/RJ45-PM or ICDM-RX/TCP-DB9/RJ45-PM2.
d. Insert the M4 screw into the hole and tighten with a Phillips screwdriver.
e. Repeat Steps b through d with the second DIN rail clip. Make sure the screws on
both DIN rail clips line up.
Note: If you need to remove the ICDM-RX/TCP-DB9/RJ45-PM or ICDM-RX/TCP-
DB9/RJ45-PM2 from the DIN rail, exert pressure on the backside of the
tabs at the bottom of both DIN rail clips.
DIN Rail
Clip
M4
Side View
Press here
10
Advertisement
Table of Contents
Troubleshooting
