Accessing Redboot Commands In Telnet/Ssh Sessions (Portvision Dx) - Pepperl+Fuchs ICDM-RX/TCP-DB9/RJ45-PM Installation And Configuration Manual

ICDM-RX/TCP Installation and Configuration Guide

Accessing RedBoot Commands in Telnet/SSH Sessions (PortVision DX)

8.14. Accessing RedBoot Commands in Telnet/SSH Sessions
(PortVision DX)
You can open a Telnet or SSH session using PortVision DX to access RedBoot commands.
Use the following procedure to access a telnet or SSH session with PortVision DX.
1. In PortVision DX, PortVision DX, right-click the ICDM-RX/TCP for which you want to open a telnet session,
and click Telnet/SSH Session.
2. Select Telnet or SSH, leave the Selected Port number, and click OK
3. If necessary, enter the password and press Enter. If a password has not been set, press Enter. If using an
SSH session, enter admin as the login and press Enter.
If the PuTTY screen flashes in the background and does not appear as shown above, make sure that
Enable Telnet/ssh has not been disabled in the web page. To check this, return to PortVision DX, right-
click the ICDM-RX/TCP, and click Webpage. Click the Network | Security and verify that the Enable
Telnet/ssh option is enabled, If it is not, click the option and then click Save, and close the web interface.
4. Type Reset, press Enter, and close the telnet session.
5. Quickly re-open the telnet or SSH session using the previous steps.
109