Table of Contents
Advertisement
ICDM-RX/TCP Installation and Configuration Guide
Determining the Network Settings
9.4. Determining the Network Settings
If you are not sure what the network information is on an ICDM-RX/TCP, you can perform the following
procedure.
The default network settings are:
•
IP address: 192.168.250.250
•
Subnet mask: 255.255.0.0
•
Gateway address: 192.168.250.1
1. Establish communications with the ICDM-RX/TCP using the serial (Page 112) or telnet (Page 113) method.
2. At the RedBoot prompt, type ip.
The IP address, subnet mask, and IP gateway values will display.
Note: Optionally, you can install PortVision DX on a Windows system on the network and see the IP
information.
9.5. Configuring the Network Settings
Use the following procedure to program the IP address using RedBoot.
1. Establish communications with the ICDM-RX/TCP using the serial (Page 112) or telnet (Page 113) method.
2. Enter ip [addr mask gateway] and press the Enter key to configure the IP address. Where:
addr = IP address you want to use
mask = matches you network subnet mask
gateway = assigned by your network administrator
Make sure that each value is separated by a space.
RedBoot>dis
Loading disabled
RedBoot> ip
RedBoot>
IP:
192.168.11.152
Mask: 255.255.00
Gateway: 192.168.0.254
RedBoot> reset
.. Resetting
3. Verify that RedBoot responds with your configured network information or reissue the command.
4. Type reset to reset the ICDM-RX/TCP, if you do not have any other related RedBoot tasks.
192.168.11.152 255.255.0.0 192.168.0.254
114
Advertisement
Table of Contents
Troubleshooting
