Adding A Unit To An Existing Installation - Pepperl+Fuchs ICDM-RX/TCP-DB9/RJ45-PM Installation And Configuration Manual

ICDM-RX/TCP Installation and Configuration Guide

Adding a Unit to an Existing Installation

4. Verify that the Status LED has completed the boot cycle and network connection for the ICDM-RX/TCP is
functioning properly using the table below.
ICDM-RX/TCP-16DB9/RJ45-RM, ICDM-RX/TCP-16RJ45/RJ45-RM, and
The amber Status LED on the device is lit, indicating you have power and it has completed the
boot cycle.
Note: The Status LED flashes while booting and it takes approximately 15 seconds for the
Status
Bootloader to complete the cycle. When the Bootloader completes the cycle, the LED
has a solid, steady light that blinks approximately every 10 seconds. For additional LED
information, go to the Status LED table on Page 148.
The red LNK/ACT LED is lit, indicating that you have a working
LNK/ACT
Ethernet connection.
Duplex If the red Duplex LED is lit, it indicates full-duplex activity.
If the red 100 LED is lit, it indicates a working 100 MB Ethernet
100 connection (100 MB network, only). If the LED is not lit, it indicates a
10 MB Ethernet connection.
Note: The port LED activity may be inconsistent until the port has been opened. After a port is opened,
LED activity works as documented.
5. Go to Initial Configuration on Page 26 to configure the ICDM-RX/TCP for use.

2.10. Adding a Unit to an Existing Installation

Use this procedure to add another ICDM-RX/TCP to an existing configuration.
1. Install the ICDM-RX/TCP to an Ethernet hub or server NIC using the appropriate subsection found in this
chapter.
Note: Technical support recommends installing one unit at a time and testing that unit when installing
multiple units. In the event troubleshooting must be done, a single unit is easier to resolve than
several at once.
2. Power-up the new ICDM-RX/TCP and verify that the PWR or STATUS LED lights.
3. Program an IP address into the new ICDM-RX/TCP using PortVision DX.
4. If necessary, upload the latest firmware.
5. Configure serial ports to support the serial devices or upload configuration files from PortVision DX.
6. Connect the serial devices.
ICDM-RX/TCP-32RJ45/2RJ45-RM LED Descriptions
LNK/
ACT
Duplex
100
10/100 ETHERNET
24