Linux Installations - Pepperl+Fuchs ICDM-RX/TCP-DB9/RJ45-PM Installation And Configuration Manual

ICDM-RX/TCP Installation and Configuration Guide

Linux Installations

4.2. Linux Installations
Download the latest device driver for Linux: https://www.pepperl-fuchs.com.
Refer to the README file packaged with the Linux driver for driver installation and configuration procedures.
Before you install the Linux NS-Link device driver:
1. Make sure that you have programmed an appropriate network address into the ICDM-RX/TCP.
2. Make sure that you verify that you have the latest version of SocketServer loaded on the ICDM-RX/TCP.
3. Open SocketServer to check the version by opening your browser and entering the IP address of the
ICDM-RX/TCP.
4. Contact Technical Support at https://www.pepperl-fuchs.com to check for the latest SocketServer version.
5. If necessary, upload the latest version.
Note: Technical Supports recommends that you update to the latest version of SocketServer before installing
an NS-Link device driver.
6. Install and configure the Linux device driver using the Readme file packaged with the driver.
32