Table of Contents
Advertisement
ICDM-RX/TCP Installation and Configuration Guide
Managing the ICDM-RX/TCP
8. Managing the ICDM-RX/TCP
This section discusses the following ICDM-RX/TCP maintenance procedures:
•
Rebooting the ICDM-RX/TCP
•
•
Note: You can configure the network addresses for multiple ICDM-RX/TCPs, configure common settings
for the ICDM-RX/TCPs, and save the settings to a configuration file that you can use to load
settings up to all or selected ICDM-RX/TCPs.
•
Adding a New Device in PortVision DX on Page 90
•
Using SocketServer Configuration Files on Page 92
•
Using Driver Configuration Files on Page 95
•
Changing the Bootloader Timeout on Page 98, which discusses changing the Bootloader timeout
•
Managing Bootloader on Page 100, which also discusses checking the Bootloader version and
downloading the latest Bootloader
•
Checking the NS-Link Version on Page 102
•
Restoring Serial Port Settings on Page 102
•
Restoring Defaults on Page 107
•
•
Note: You can optionally refer to RedBoot Procedures on Page 111 if you want to perform procedures at the
RedBoot level.
8.1. Rebooting the ICDM-RX/TCP
There are many ways to reboot the ICDM-RX/TCP.
Method
Right-click the ICDM-RX/TCP or shift-click the ICDM-RX/TCPs and click Advanced
>Reboot and then Yes.
PortVision DX
Note: If security has been enabled in the web page, you will need to reboot the ICDM-
System | Reboot: You have 10 seconds to Cancel before the ICDM-RX/TCP
Web page
automatically reboots. Optionally, you can click Reboot Now.
Telnet
Type reset.
ICDM-RX/TCP DIN rail models have a Reset/Restore switch.
•
If the Reset/Restore switch is depressed for less than 2 seconds, the ICDM-RX/TCP
ICDM-RX/TCP
reboots.
DIN Rail Models
•
If the Reset/Restore switch is depressed for greater than approximately 5 seconds it
restores the ICDM-RX/TCP to the factory default values.
RX/TCP in the web page.
Procedure
89
Advertisement
Table of Contents
Troubleshooting
