Uploading Socketserver To Multiple Icdm-Rx/Tcps; Configuring Multiple Icdm-Rx/Tcps Network Addresses; Adding A New Device In Portvision Dx - Pepperl+Fuchs ICDM-RX/TCP-DB9/RJ45-PM Installation And Configuration Manual

ICDM-RX/TCP Installation and Configuration Guide

Uploading SocketServer to Multiple ICDM-RX/TCPs

8.2. Uploading SocketServer to Multiple ICDM-RX/TCPs

You can use this procedure if your ICDM-RX/TCP is connected to the host PC, laptop, or if the ICDM-RX/TCP
resides on the local network segment.
1. If you have not done so, install PortVision DX (Installing PortVision DX on Page 27) and Scan the network.
2. Shift-click the multiple ICDM-RX/TCPs right-click and then click Advanced > Upload Firmware.
3. Browse, click the firmware (.cmtl) file, Open (Please locate the new firmware), and then click Yes (Upload
Firmware).
It may take a few moments for the firmware to upload onto the ICDM-RX/TCP. The ICDM-RX/TCP reboots
itself during the upload process.
4. Click Ok to the advisory message about waiting to use the device until the status reads ON-LINE.
In the next polling cycle, PortVision DX updates and displays the new firmware version. If necessary, you can
click Refresh.

8.3. Configuring Multiple ICDM-RX/TCPs Network Addresses

You can configure the network addresses for multiple ICDM-RX/TCPs using the Assign IP to Multiple
Devices option.
In addition, you can also configure common settings for the ICDM-RX/TCP SocketServer or NS-Link web page
and save the settings to a configuration file that you can load to all or selected ICDM-RX/TCPs.
The ICDM-RX/TCPs must be on the same network segment
for this procedure to work. Use the following steps to
configure multiple ICDM-RX/TCPs.
1. If you have not done so, install PortVision DX (Installing
PortVision DX on Page 27) and Scan the network.
2. Shift-click the ICDM-RX/TCPs for which you want to
program network information, right-click, and click
Advanced > Assign IP to Multiple Devices.
3. Enter the starting IP address, subnet mask, IP Gateway
and click Proceed.
PortVision DX displays the programmed IP addresses
after the next refresh cycle.

8.4. Adding a New Device in PortVision DX

You can add a new ICDM-RX/TCP manually, if you do not want to scan the network to locate and add new
ICDM-RX/TCPs, but there may be cases where you want to use the Add New Device window to:
• Configure ICDM-RX/TCP units that are not on the local network (remote) using Remote Using the IP
Address on Page 91.
• Pre-configure an ICDM-RX/TCP in PortVision DX (local) using Local Using the IP Address or MAC Address
on Page 92.
90