Table of Contents
Advertisement
ICDM-RX/TCP Installation and Configuration Guide
Windows Installations
4.3. Windows Installations
This subsection provides an installation overview for the NS-Link device driver for Windows. For detailed
installation and configuration information, see the ICDM-RX/TCP Device Driver (NS-Link) help system.
4.3.1. Supported Operating Systems
The NS-Link device driver for Windows supports Windows 2008 R2 through Windows 11 and Windows Server
2019.
If you are updating the driver or need to remove the NS-Link device driver, you can refer to the help system.
Note: Administrative privileges are required to install device drivers on Windows systems.
4.3.2. Installation Overview for Windows
The following NS-Link device driver installation and configuration procedures are discussed in this subsection:
•
Install the NS-Link device driver and ICDM-RX/TCP Windows Drivers Management Console using the
Installation Wizard.
•
Configure the COM ports using the Windows Drivers Management Console.
•
Configure device properties using the Windows Drivers Management Console.
4.3.3. NS-Link for Windows Installation
1. Locate the NS-Link device driver and make it available to the host system. The driver assembly is available
at: https://www.pepperl-fuchs.com.
2. Unzip the file and then execute the driver assembly DeviceMaster_ICDM-RX_Driver_x.xx.exe file and
click Next to start the installation.
3. Click Yes to the Do you want to allow this app to make changes to your device? screen.
4. Click Next to install in the default location.
5. Click Install.
6. Leave the Launch ICDM-RX Driver Installation box checked.
If you do not check this box, you can use the shortcut under the Start button at: Pepperl+Fuchs > ICDM-
RX Driver Installation Wizard.
7. Click Finish to complete the installation of the wizard.
8. Click Next to start the driver installation.
9. Click Install and Next.
10. Select the ICDM-RX/TCP model that you are installing from the list.
11. Enter the quantity of this ICDM-RX/TCP model that you want to install and click Ok.
12. Repeat Steps 10 and 11 for each ICDM-RX/TCP that you are installing and then click Next.
13. Click Next.
14. Click Proceed.
You may see the popup at the right for each port, depending on the operating system.
15. If this is a self-certified driver, click the Install button..
16. Return to the Installation Wizard and click Close.
33
Advertisement
Table of Contents
Troubleshooting
