ICDM-RX/TCP Installation and Configuration Guide
Connecting Serial Devices
7. Connecting Serial Devices
This section discusses connecting your serial devices to the ICDM-RX. It also provides you with information to
build serial or test cables and loopback connectors to test the serial ports.
•
DB9 Connectors on Page 77
•
RJ45 Connectors on Page 80
•
Four Screw Terminals (ICDM-RX/TCP-2ST/RJ45-DIN) on Page 83
•
Nine Screw Terminals (ICDM-RX/TCP-ST/RJ45-DIN) on Page 86
Make sure that you have configured the ports for the correct communications mode before
connecting any devices. The default mode is RS-232. There is a remote possibility that
Caution
connecting a serial device for the wrong mode could damage the serial device.
76