Icdm-Rx/Tcp-St/Rj45-Din Installation - Pepperl+Fuchs ICDM-RX/TCP-DB9/RJ45-PM Installation And Configuration Manual

ICDM-RX/TCP Installation and Configuration Guide

ICDM-RX/TCP-ST/RJ45-DIN Installation

2.2. ICDM-RX/TCP-ST/RJ45-DIN Installation

Use the following procedure to install the ICDM-RX/TCP-ST/RJ45-DIN. See ICDM-RX/TCP-DB9/RJ45-DIN
Installation on Page 14 if the ICDM-RX/TCP has DB9 serial connectors.
1. Attach the ICDM-RX/TCP-ST/RJ45-DIN 1-Port to the DIN rail adapter.
2. Connect the power supply and apply power to the ICDM-RX/TCP-ST/RJ45-DIN using the power supply
specifications on the product label and the following information.
Observe proper ESD techniques when connecting and disconnecting the ICDM-RX/TCP-
ST/RJ45-DIN.
a. If the DIN rail is not connected to earth ground, insert the earth ground wire into the chassis ground
screw terminal.
Note: The chassis ground connection is made only if
the DIN rail is NOT connected to earth ground.
b. Insert the DC positive wire into the + screw terminal
and the DC return wire into the - screw terminal.
Refer to ICDM-RX/TCP-DB9/RJ45-DIN or ICDM-
RX/TCP-ST/RJ45-DIN Power Supply on Page 121
for detailed power requirements.
c. Use a small flat head screw driver to lock the wires
into place.
d. Verify that each wire has been tightened securely.
e. Connect a UL Listed power supply and UL Listed
power cord to a power source to apply power.
Note: Do not connect multiple units until you have
changed the default IP address, see Initial
Configuration on Page 26.
3. Connect the 10/100 port to the same Ethernet network segment as the host PC using a standard network
cable.
4. Verify that the STATUS LED has completed the boot cycle and network connection for the ICDM-RX/TCP-
ST/RJ45-DIN is functioning using the following table.
The STATUS LED on the device is lit, indicating you have power and it has completed the
boot cycle.
STATUS
The Status LED flashes while booting and it takes approximately 15 seconds for the
Bootloader to complete the cycle. When the Bootloader completes the cycle, the LED has
a solid, steady light that blinks approximately every 10 seconds.
LINK If the LINK (green) LED is lit, it indicates a working Ethernet connection.
ACT If the ACT (yellow) LED flashes, it indicates network activity.
Note: For additional LED information, go to the Status LED table on Page 127.
Do not connect RS-422/485 devices until the IP address is configured and an
appropriate port interface type has been configured. The default port setting is RS-232.
5. Go to Initial Configuration on Page 26 to configure the ICDM-RX/TCP for use.
ICDM-RX/TCP-ST/RJ45-DIN LED Descriptions
Positive† Positive†
Return†
5-30VDC 5-30VDC
PW1 PW2
† Wire gauge: AWG 12-22
Chassis
Ground†
13