Accessing Socketserver Commands In Telnet/Ssh Sessions (Portvision Dx); Telnet Session - Pepperl+Fuchs ICDM-RX/TCP-DB9/RJ45-PM Installation And Configuration Manual

ICDM-RX/TCP Installation and Configuration Guide

Accessing SocketServer Commands in Telnet/SSH Sessions (PortVision DX)

3. Click the Port Settings (including RFC1006) option and then click Restore.
You will be able to log in after the reboot cycle.
8.12. Accessing SocketServer Commands in Telnet/SSH Sessions
(PortVision DX)
You can open a Telnet or SSH session using PortVision DX. Use the appropriate procedure for your site:
• Telnet Session (below)
• SSH Session on Page 105

8.12.1.Telnet Session

Use the following procedure to access a telnet session with PortVision DX.
1. In PortVision DX, PortVision DX, right-click the ICDM-RX/TCP for which you want to open a telnet session,
and click Telnet/SSH Session.
2. Leave the popup set to Telnet and Selected Port 23, and click OK
103