Table of Contents
Advertisement
ICDM-RX/TCP Installation and Configuration Guide
PortVision DX - Saving a SocketServer Configuration File
8.5.1. PortVision DX - Saving a SocketServer Configuration File
Use this procedure to save a configuration file using the PortVision DX Main screen.
Note: Optionally, you can save a configuration file by accessing the Software Settings tab in the Properties
screen and then clicking the Save Settings to a File button.
1. If you have not done so, install PortVision DX (Installing PortVision DX on Page 27) and Scan the network.
2. Right-click the ICDM-RX/TCP and then click Configuration > Save.
3. Browse to the location you want to save the file, enter a file name, and click Save.
4. Click OK to close the Save Configuration Completed message.
8.5.2. PortVision DX - Loading a SocketServer Configuration File
Use the following procedure to load a previously saved an ICDM-RX/TCP configuration file. Load a
configuration file and apply it to a selected ICDM-RX/TCP or ICDM-RX/TCPs.
Use this procedure to load a configuration file one or more ICDM-RX/TCP units.
Note: The configuration file does not need to be the same model or port density. For example, the saved
configuration file could be from an ICDM-RX/TCP-4DB9/2RJ45-DIN that you want to load on an ICDM-
RX/TCP-DB9/RJ45-DIN.
1. Highlight the device or devices, right-click and then click Configuration > Load
2. Click Yes to the warning that it will take 25 seconds per device and it may also reboot the devices.
3. Browse to the location of the configuration file, click the file name (.dc) and then Open.
4. Click the All check box or expand the Protocol Settings and select only the properties that you want to load
for each property page in the configuration file and then click Done.
Note: If you click All, every selected ICDM-RX/TCPs will be programmed with the same IP address.
5. Close the Load Configuration popup message.
93
Advertisement
Table of Contents
Troubleshooting
