Tcp/Ip Socket Port Installation Overview; Locating Software And Documentation; Connectivity Requirements - Pepperl+Fuchs ICDM-RX/TCP-DB9/RJ45-PM Installation And Configuration Manual

ICDM-RX/TCP Installation and Configuration Guide

TCP/IP Socket Port Installation Overview

1.3.3. TCP/IP Socket Port Installation Overview
Use the following steps, which are discussed in detail in the subsequent sections, to configure ICDM-RX/TCP
socket ports.
1. After connecting the ICDM-RX/TCP, programming the IP address, and uploading the latest version of
SocketServer, you are ready to configure socket port or serial tunneling.
2. Configure the serial socket ports using the PortVision DX property pages or enter the IP address in a web
browser and use the SocketServer web pages.
You can refer to the SocketServer help system or Socket Port Configuration on Page 44 for information for
configuration procedures.
3. Connect the serial devices to the ICDM-RX/TCP. Refer to Connecting Serial Devices on Page 76 for
cabling and connector information.

1.4. Locating Software and Documentation

You can access the appropriate software assembly (firmware and drivers), PortVision DX, and ICDM-RX/TCP
documentation at: https://www.pepperl-fuchs.com.

1.5. Connectivity Requirements

An Ethernet connection: either to an Ethernet hub, switch, or router; or to a Network Interface Card (NIC) in the
host system using a standard Ethernet cable.
Type Code
ICDM-RX/TCP-DB9/RJ45-PM
ICDM-RX/TCP-DB9/RJ45-PM2
ICDM-RX/TCP-DB9/RJ45-DIN
ICDM-RX/TCP-ST/RJ45-DIN
ICDM-RX/TCP-2DB9/RJ45-DIN
ICDM-RX/TCP-2ST/RJ45-DIN
ICDM-RX/TCP-4DB9/2RJ45-DIN
ICDM-RX/TCP-4DB9/2RJ45-PM
ICDM-RX/TCP-8DB9/2RJ45-PM
ICDM-RX/TCP-16DB9/RJ45-RM
ICDM-RX/TCP-32RJ45/2RJ45-RM
Connected to
Hub, switch, router, or NIC
Hub, switch, router, or NIC
Hub, switch, router, or NIC
Hub, switch, router, or NIC
Hub, switch, router, or NIC
Connector Name
10/100
ETHERNET
10/100
E1/E2
UP
DOWN
10/100 NETWORK
9