Icdm-Rx/Tcp-Db9/Rj45-Din Installation - Pepperl+Fuchs ICDM-RX/TCP-DB9/RJ45-PM Installation And Configuration Manual

ICDM-RX/TCP Installation and Configuration Guide

ICDM-RX/TCP-DB9/RJ45-DIN Installation

2.3. ICDM-RX/TCP-DB9/RJ45-DIN Installation

Use the following procedure to install the ICDM-RX/TCP-DB9/RJ45-DIN.
1. Attach the ICDM-RX/TCP-DB9/RJ45-DIN to the DIN rail adapter.
2. Connect the power supply and apply power to the ICDM-RX/TCP-DB9/RJ45-DIN using the power supply
specifications on the product label and the following information.
Observe proper ESD techniques when connecting and disconnecting the ICDM-RX/TCP-
DB9/RJ45-DIN.
a. If the DIN rail is not connected to earth ground,
insert the earth ground wire into the chassis
ground screw terminal.
Note: The chassis ground connection is made only if
the DIN rail is NOT connected to earth ground.
b. Insert the DC positive wire into one of the + screw
terminals and the DC return wire into the - screw
terminal.
• A second redundant power supply can be
connected to the unit by inserting the DC
positive wire into the other + screw terminal
and the DC return wire into the - screw
terminal.
• The ICDM-RX/TCP-DB9/RJ45-DIN continues
to operate if one of the two connected power
supplies should fail.
Refer to ICDM-RX/TCP-DB9/RJ45-DIN or ICDM-RX/TCP-ST/RJ45-DIN Power Supply on Page 121 for
detailed power requirements.
c. Use a small flat head screw driver to lock the wires into place.
d. Verify that each wire has been tightened securely.
e. Connect a UL Listed power supply and UL Listed power cord to a power source to apply power.
Note: Do not connect multiple units until you have changed the default IP address, see Initial Configuration on
Page 26.
3. Connect the 10/100 port to the same Ethernet network segment as the host PC using a standard Ethernet
cable.
Positive† Positive†
Return†
5-30VDC 5-30VDC
PW1
PW2
† Wire gauge: AWG 12-22
Chassis
Ground†
14