Table of Contents
Advertisement
ICDM-RX/TCP Installation and Configuration Guide
Loading Configuration Files
8.8.2. Loading Configuration Files
Use the following procedure to load configuration files.
1. If necessary, enter the IP address in your browser.
2. Click System | Configuration File.
3. Click the Browse button and select the configuration file. The default configuration file name is:
dm_xxx.xxx.xxx.xxx.ds
Where xxx.xxx.xxx.xxx is the IP address and .ds is the file extension.
4. Click the Load Configuration button.
8.9. Managing Bootloader
Bootloader refers to the operating system that runs on the ICDM-RX/TCP hardware during the power on phase,
which then loads SocketServer.
Note: Typically, you should not update the Bootloader unless advised to do so by Pepperl+Fuchs Technical
Support.
There are several methods and tools that you can use to check the Bootloader version or update the
Bootloader.
•
PortVision DX is the easiest way to check the Bootloader version and upload the latest version.
•
Optionally, RedBoot can be used to check the Bootloader version and update the Bootloader. See
RedBoot Procedures on Page 111 for procedures.
8.9.1. Checking the Bootloader Version
The following procedure uses PortVision DX to check the Bootloader version. Optionally, you can use RedBoot,
see Determining the Bootloader Version on Page 115.
1. If you have not done so, install PortVision DX (Installing PortVision DX on Page 27) and Scan the network.
2. Right-click the ICDM-RX/TCP and click Advanced > Reboot.
100
Advertisement
Table of Contents
Troubleshooting
