Bay-Tek CONNECT 4 HOOPS Service Manual page 19

CONNECT 4 HOOPS GAME SETUP
Allow game to boot up and inspect the picture quality. The projector may need to be adjusted.
If the screen picture is out of focus or too small, reach up
into the marquee opening where the projection is emitted.
There are 2 levers on the projector.
One is for focus, the other for zoom.
If the screen picture is off to the side or height is off, the wood box holding the projector will have to
be adjusted. This is not common.
Remove the small front marquee and unlock and open the front door
in the marquee.
Loosen these bolts to adjust the projector up and down.
Loosen these bolts to adjust the projector left and right.
Ensure the USB cable from the rear controller board is plugged into any of the USB slots on the
motherboard.
The game is now set up and ready for play!
Enter menu to adjust settings to your location specific price per play and ticket payout.
19